Exposure Assessment of Essential and Potentially Toxic Metals in Wheat-Based Sweets for Human Consumption: Multivariate Analysis and Risk Evaluation Studies.

In recent years, there has been a growing concern about the negative impact of unforeseen contaminants such as metals in commonly consumed food items, which pose a threat to human well-being. Therefore, it is of utmost importance to evaluate the levels of these contaminants to guarantee the safe consumption of these food items. The goal of the current research is to determine the levels of essential (EMs: Mg, Ca, Mn, Fe, Co, Cu, and Zn) and potentially toxic metals (PTMs: Al, Cr, Ni, As, Cd, and Pb) in various brands of wheat-based sweets. One hundred samples were collected and analysed via flame atomic absorption spectrometry (FAAS) and inductively coupled plasma-optical emission spectrometry (ICP-OES). Also, the current study was to investigate the distribution, correlation, and multivariate analysis of 13 metals (Mg, Ca, Mn, Fe, Co, Cu, Zn, Al, Cr, Ni, As, Cd, and Pb). Hierarchical cluster analysis (HCA) and principal component analysis (PCA) were used to interpret the metals' association. The concentration (mg/kg) ranges of EMs were, in order, Mg (12.70-65.67), Ca (24.02-209.12), Mn (1.32-9.61), Fe (4.55-111.23), Co (0.32-8.94), Cu (2.12-8.61), and Zn (2.60-19.36), while the concentration (mg/kg) ranges of PTMs were, in order, Al (0.32-0.87), Cr (0.17-5.74), Ni (0.36-1.54), Cd (0.16-0.56), and Pb (0.14-0.92), and As was not detected in any sample under investigation. The HCA data revealed that Co, Al, and Ni form clusters with other metals. Sweets are prepared at high temperatures, and the elevated temperatures can increase the likelihood of Ni and Al leaching from stainless steel. Tolerable dietary intake (TDI) values for Ni were higher than the values established by the European Food Safety Authority (EFSA). The CR value found for the Ni and Cr was at the threshold level of cancer risk, if an amount of 25 g were to be used over a lifetime. In a nutshell, this study highlights the monitoring of EM and PTM levels in wheat-based sweets, and from a food safety perspective, the study is important for consumers of wheat-based sweets.

ENSEAL® Hemorrhoidectomy, a Novel Technique, Versus Conventional Open Method for the Management of Grade III and IV Hemorrhoids.

Background Surgical removal of hemorrhoids is the gold-standard treatment for symptomatic grade III and IV hemorrhoid disease. There are numerous ways the hemorrhoidectomy surgical procedure is done but the most effective and least painful way is still to be elucidated. Objective To compare the outcomes of ENSEAL® (Ethicon, Inc., Raritan, USA) versus gold standard Milligan-Morgan hemorrhoidectomy in patients presenting with grade-III and IV hemorrhoids Materials and methods After ethical approval, the Randomized Controlled Trial was conducted at the Department of Surgery, Unit III, Lahore General Hospital, Lahore, Pakistan, between January 2020 and January 2022. In this study, 140 patients who met the inclusion criteria were recruited after informed consent. Patients were split randomly into two equal groups using a lottery technique. In group A, hemorrhoidectomy was carried out with ENSEAL®, whereas in group B, open hemorrhoidectomy was performed by the Milligan-Morgan method. the surgery duration and blood loss were noted. After the operation, patients were transferred to and discharged from the post-anesthesia recovery room. Patients were further followed up for pain scores after 24 hours. Data was analyzed by using Statistical Package for Social Sciences (SPSS) v25 (IBM Corp., Armonk, USA). Data was categorized for age, gender, body mass index (BMI), degree of hemorrhoids, and duration of hemorrhoids. A p-value <0.05 was considered significant. Results 140 patients were included in this study. Group A patients underwent ENSEAL® hemorrhoidectomy, and group B was formed from those who underwent the Milligan-Morgan procedure. In group A, there were 41 (58.5%) males and 29 (41.4%) females, while in group B, there were 43 (61.4%) males and 27 (38.5%) females. The mean age of group A patients was 49.97 ± 7.36 years and 43.2 ± 8.01 years in group B. In group A, the mean operative time was 20.87 ± 3.05 min, while 27.10 ± 3.42 min in group B, which is statistically significant with a p-value of <0.001. In group A, mean blood loss was 9.79 ± 2.87 ml, while 13.36 ± 3.73 ml in group B, which is statistically significant with a p-value of <0.001. In group A, the mean pain score was 2.7 ± 1.08, while 3.34 ± 1.16 in group B, which is statistically significant with a p-value of <0.001. Conclusion When considering the length of the procedure and blood loss, ENSEAL® hemorrhoidectomy has been determined to be an effective treatment that the patients tolerated well. Therefore, ENSEAL® hemorrhoidectomy can be a safe and efficient alternative to conventional treatment for hemorrhoids that are causing symptoms.

Fatty acids characterization and oxidative stability of spray dried designer egg powder.

BACKGROUND: Designer eggs (DEs) have gained positive importance in maintaining cholesterol level, triglyceride profile and protection towards cardiovascular diseases due to the presence of essential fatty acids (EFAs) such as omega-3 (or) n-3 fatty acids. However, extreme heat conditions effect the quality as well as quantity of EFAs during the production of designer egg dried powder (DEDP). Therefore, the main mandate of research was the development of DEDP and determination of spray drying conditions impact on fatty acids composition of DEDP samples. METHODS: The DEs were produced, collected, de-shelled, homogenized and diluted before spray drying to get fine powder. The spray drying of DEs was carried out using a laboratory spray drier. An experimental design was used for the drying parameters, where the inlet air temperature was varied (160, 180 and 200 °C), feed flow rate (200, 300 and 400 mL/hr), atomization speed (16,000, 20,000 and 24,000 rpm) and outlet air temperature (60, 70 and 80 °C) at different levels. For convenience of experimental design coding was used. The DEDP was collected in a single cyclone separator and was stored after packaging for consecutive 2 months at 25 °C and 4 °C, respectively. The powder yield was calculated from the collected dry mass in the collecting vessel divided by the processed whole egg diluted matter. The total lipids of DEDP samples were determined gravimetrically. The esters of fatty acids in each sample were prepared and analyzed through Gas Chromatograph apparatus. The oxidative stability of DEDP samples was estimated by following standard procedure of peroxide value. RESULTS: The powder yield of DEDP as a result of different operating conditions was found in the range of 30.06 ± 0.22 g/500 mL to 62.10 ± 0.46 g/500 mL DEs sample. The decreasing trend in moisture content (4.4 ± 0.16% towards 4.0 ± 0.09%) and total fat content (45 ± 0.65 g/100 g towards 41 ± 0.35 g/100 g) in DEDP samples was observed with increased inlet and outlet temperature while fat content increased at high feed flow rate and atomization speed. In this study, loss of PUFAs in DEDP samples was followed due to their active role regarding to human health. For alpha-linolenic (ALA) fatty acids, maximum value at 4 °C observed was 127.32 ± 0.27 mg/50 g egg and 124.43 ± 0.32 mg/50 g egg while the minimum value observed for ALA was 100.15 ± 0.09 mg/50 g egg and 97.15 ± 0.06 mg/50 g egg after 30 and 60 days storage, respectively. The significant decrease trend for eicosapentaenoic (EPA) fatty acids values from 11.78 ± 0.31 mg/50 g egg to 2.18 ± 0.14 mg/50 g egg at 25 °C under spray dried conditions of inlet air temperature (180 °C), feed flow rate (300 mL/hr), atomization speed (24,000 rpm) and outlet air temperature (80 °C) after 60 days storage period was noted. The docosahexaenoic (DHA) fatty acids value in DEDP was decreased from 15.49 ± 0.79 mg/50 g egg (0 day) to 10.10 ± 0.64 mg/50 g egg at 60 days (4 °C) and same decreasing trend was observed at 25 °C. The decreasing order for total omega-3 fatty acids retention in DEDP during storage intervals was found as 162.33 ± 1.64 mg/50 g egg > 158.61 ± 1.53 mg/50 g egg > 148.03 ± 1.57 mg/50 g egg (0, 30 and 60 days stored at 4 °C) and 162.33 ± 1.64 mg/50 g egg > 151.56 ± 1.54 mg/50 g egg > 135.89 ± 1.62 mg/50 g egg (0, 30 and 60 days stored at 25 °C). The peroxide value (PV) levels obtained in DEDP samples after 60 days were higher (0.78 ± 0.06, 0.81 ± 0.02 meq/kg O2) when compared to initial readings at 0 day (0.65 ± 0.04 meq/kg O2). The PV of DEDP samples reached their maximum peaks after 60 days at 25 °C. The increasing order showed that lipid oxidation increased with storage. However, the overall PV never exceeded the limit of 10 (meq/kg) considered as a threshold limit. CONCLUSIONS: Extreme hot conditions (> 180 °C) of spray dryer reduce the quality of designer egg dry powder. Extreme conditions assist PUFAs loss and decrease in storage stability due to high lipid oxidation.

Design of Embedded System for Multivariate Classification of Finger and Thumb Movements Using EEG Signals for Control of Upper Limb Prosthesis.

Brain Computer Interface (BCI) determines the intent of the user from a variety of electrophysiological signals. These signals, Slow Cortical Potentials, are recorded from scalp, and cortical neuronal activity is recorded by implanted electrodes. This paper is focused on design of an embedded system that is used to control the finger movements of an upper limb prosthesis using Electroencephalogram (EEG) signals. This is a follow-up of our previous research which explored the best method to classify three movements of fingers (thumb movement, index finger movement, and first movement). Two-stage logistic regression classifier exhibited the highest classification accuracy while Power Spectral Density (PSD) was used as a feature of the filtered signal. The EEG signal data set was recorded using a 14-channel electrode headset (a noninvasive BCI system) from right-handed, neurologically intact volunteers. Mu (commonly known as alpha waves) and Beta Rhythms (8-30 Hz) containing most of the movement data were retained through filtering using "Arduino Uno" microcontroller followed by 2-stage logistic regression to obtain a mean classification accuracy of 70%.

Fatty acids characterization, oxidative perspectives and consumer acceptability of oil extracted from pre-treated chia (Salvia hispanica L.) seeds.

BACKGROUND: Chia (Salvia hispanica L.) seeds have been described as a good source of lipids, protein, dietary fiber, polyphenolic compounds and omega-3 polyunsaturated fatty acids. The consumption of chia seed oil helps to improve biological markers related to metabolic syndrome diseases. The oil yield and fatty acids composition of chia oil is affected by several factors such as pre-treatment method and size reduction practices. Therefore, the main mandate of present investigate was to study the effect of different seed pre-treatments on yield, fatty acids composition and sensory acceptability of chia oil at different storage intervals and conditions. METHODS: Raw chia seeds were characterized for proximate composition. Raw chia seeds after milling were passed through sieves to obtain different particle size fractions (coarse, seed particle size ≥ 10 mm; medium, seed particle size ≥ 5 mm; fine, seed particle size ≤ 5 mm). Heat pre-treatment of chia seeds included the water boiling (100 C°, 5 min), microwave roasting (900 W, 2450 MHz, 2.5 min), oven drying (105 ± 5 °C, 1 h) and autoclaving (121 °C, 15 lbs, 15 min) process. Extracted oil from pre-treated chia seeds were stored in Tin cans at 25 ± 2 °C and 4 ± 1 °C for 60-days and examined for physical (color, melting point, refractive index), oxidative (iodine value, peroxide value, free fatty acids), fatty acids (palmitic, stearic, oleic, linoleic, α-linolenic) composition and sensory (appearance, flavor, overall acceptability) parameters, respectively. RESULTS: The proximal composition of chia seeds consisted of 6.16 ± 0.24 % moisture, 34.84 ± 0.62 % oil, 18.21 ± 0.45 % protein, 4.16 ± 0.37 % ash, 23.12 ± 0.29 % fiber, and 14.18 ± 0.23 % nitrogen contents. The oil yield as a result of seed pre-treatments was found in the range of 3.43 ± 0.22 % (water boiled samples) to 32.18 ± 0.34 % (autoclaved samples). The oil samples at day 0 indicated the maximum color (R and Y Lovibond scale) value for oven drying while at storage day 60 (25 ± 2 °C), the highest color value was found for autoclave pre-treatment. The slightly increasing trend of color values for all treatments was observed during the storage period. The lowest iodine value (182.83 ± 1.18 g/100 g at storage day 0 & 173.49 ± 1.21 g/100 g at storage day 60, 25 ± 2 °C) was calculated for autoclaved samples while the maximum iodine value (193.42 ± 1.14 g/100 g at storage day 0 & 190.36 ± 1.17 g/100 g at storage day 60, 25 ± 2 °C) was recorded for raw chia samples. The significant increasing trend for all treatments was observed in case of peroxide value and free fatty acids production during storage. Maximum decrease in linoleic (35 %) and α-linolenic (18 %) fatty acids was observed in autoclaved samples. The oil from pre-treated seed samples obtained decreasing scores for sensory parameters throughout the storage period at different conditions. CONCLUSIONS: As a result, chia seeds are an important source of lipids and essential fatty acids. The water boiling and high temperature processing of chia seeds provides instability to lipids during storage at room temperature. However, detailed investigation is required on the processing performance and storage stability of food products supplemented with pre-treated chia seeds and furthers their effect on biological system.